Cisco A9K-4X100GE-TR Bay Networks will help you procure ASR 9000 4 port and 8 port 100Gig network cards for Cisco ASR series router for ISP and Large enterprises The Cisco ASR 9000 Series 4-port Line Card 100 Gigabit Ethernet Line Card deliver industry-leading high density, with line-rate 100 Gigabit Ethernet ports, to any slot of a Cisco ASR 9000 Series Aggregation Services Router. These high-capacity line cards are designed to remove bandwidth bottlenecks in the network that are caused by a large increase in video-on-demand (VoD), IPTV, point-to-point video, Internet video, and cloud services traffic. A single 100 Gigabit Ethernet port can now replace large 10 Gigabit Ethernet link aggregation bundles to simplify network operations. Based on Cisco CPAK technology, this line card has flexible interfaces that support 100 Gigabit Ethernet, 40 Gigabit Ethernet and 10 Gigabit Ethernet modes, so it gives customers the flexibility to mix and match interface types on the same line card. ASR 9000 Series 4-port 100 Gigabit Ethernet line cards are fully compatible with Cisco ASR 9006 Router, ASR 9010 Router, ASR 9904 Router, ASR 9912 Router, and ASR 9922 Router. However, their chassis may require a hardware update for the cooling and power systems, because the line cards offer industry‑leading, high-density 100 Gigabit Ethernet throughput. The 4-port and 8-port line cards are both designed to support full line rate in non-oversubscribed fashion. The ASR 9000 Series can extend 100 Gigabit Ethernet transport over an IP-over-dense-wave-division-multiplexing (IPoDWDM) network when used with the Cisco ONS 15454 DWDM transponder solution. Distances of up to 3000 kilometers can be achieved while using the optical protection capabilities of the DWDM network. Product Specifications Description Specification Chassis compatibility Compatible with the Cisco ASR 9006, ASR 9010, ASR 9904, ASR 9912 and ASR 9922 chassis Port density 4-ports of 100 Gigabit Ethernet per line card Ethernet ● 100-Gbps IEEE 802.3ba compliant ● 100 Gigabit Ethernet PHY monitoring ● IEEE 802.x flow control ● Full-duplex operation ● Per-port byte and packet counters for policy drops; oversubscription drops; cyclic redundancy check (CRC) error drops; packet sizes; and unicast, multicast, and broadcast packets Performance ● 100-Gbps line-rate throughput per port Options Each line card is available as either a service edge optimized (enhanced QoS) or packet transport optimized (basic QoS) line card Reliability and availability Line card online insertion and removal (OIR) support without system impact Physical dimensions (H x W x D); weight 4-port 100 Gigabit Ethernet Line Card: 14.5 x 1.63 x 22.02 in.; 28 lb (est.) (368.3 mm x 41.4 mm x 559.3 mm; 12.7 kg) Operating temperature 41 to 104ºF (5 to 40ºC) Operating humidity (nominal) (relative humidity) 10 to 85% Storage temperature -40 to 158ºF (-40 to 70ºC) Storage (relative humidity) 5 to 95% Note: Not to exceed 0.024 kg of water per kg of dry air Operating altitude -60 to 4000m (up to 2000m conforms to IEC, EN, UL, and CSA 60950 requirements) ETSI standards Cisco ASR 9000 Series Routers are designed to meet: ● EN300 386: Telecommunications Network Equipment (EMC) ● ETSI 300 019 Storage Class 1.1 ● ETSI 300 019 Transportation Class 2.3 ● ETSI 300 019 Stationary Use Class 3.1 ● EN55022: Information Technology Equipment (Emissions) ● EN55024: Information Technology Equipment (Immunity) ● EN50082-1/EN-61000-6-1: Generic Immunity Standard EMC standards Cisco ASR 9000 Series Routers are designed to meet: ● FCC Class A ● ICES 003 Class A ● AS/NZS 3548 Class A ● CISPR 22 (EN55022) Class A ● VCCI Class A ● BSMI Class A ● IEC/EN 61000-3-2: Power Line Harmonics ● IEC/EN 61000-3-3: Voltage Fluctuations and Flicker Immunity Cisco ASR 9000 Series Routers are designed to meet: ● IEC/EN-61000-4-2: Electrostatic Discharge Immunity (8kV Contact, 15kV Air) ● IEC/EN-61000-4-3: Radiated Immunity (10V/m) ● IEC/EN-61000-4-4: Electrical Fast Transient Immunity (2kV Power, 1kV Signal) ● IEC/EN-61000-4-5: Surge AC Port (4kV CM, 2kV DM) ● IEC/EN-61000-4-5: Signal Ports (1kV) ● IEC/EN-61000-4-5: Surge DC Port (1kV) ● IEC/EN-61000-4-6: Immunity to Conducted Disturbances (10Vrms) ● IEC/EN-61000-4-8: Power Frequency Magnetic Field Immunity (30A/m) ● IEC/EN-61000-4-11: Voltage DIPS, Short Interruptions, and Voltage Variations Safety Cisco ASR 9000 Series Routers are designed to meet: ● UL/CSA/IEC/EN 60950-1 ● IEC/EN 60825 Laser Safety ● ACA TS001 ● AS/NZS 60950 ● FDA: Code of Federal Regulations Laser Safety
